What is the reason why the ice water unit is turned on?

Over the years in the East Leap into refrigeration chiller equipment, one customer said that the chiller will trip when it is turned on. When the ice water machine is turned on, it will jump off and directly power off. What is the reason? If it is a jump phenomenon after a few minutes of starting up, what is the cause? So, Dongyuejin Refrigeration Xiaobian is here to share with you. What is the reason why the chiller is turned on and off.

The failure of the chiller to start the trip is caused by the following reasons:

1. There is a short circuit in the circuit part. This kind of situation generally occurs when the chiller has been used for a long time. Everyone knows that it takes a long time to use it for 10 years. Many of them are still running 24 hours a day, so the circuit should be checked regularly. .

2. The circuit part is flooded. After the unit has been in use for a long time, it will inevitably have dust and other debris, so it will be cleaned. However, keep in mind that it is not possible to clean directly with water, or that the cleaning tool has water, which may cause the circuit to partially enter the water.

3. The operation panel is replaced or water is introduced. The situation is the same as article 2. When replacing the control panel, you should choose the same model of the same brand, and the wiring should be accurate.

4. The internal motor of the compressor is burnt. The probability of occurrence is not high, as long as more attention is observed during daily use, and the ice water unit is regularly maintained.

5. The chiller refrigeration system may cause a large current due to blockage or poor heat dissipation, resulting in a tripping phenomenon.

Therefore, when there is a situation in which the chiller is turned on, we should check it one by one according to the reason, and then restart it after confirming that there is no problem. It is still impossible to solve the problem after conducting the investigation. It is recommended to directly find the chiller manufacturer for after-sale treatment.