Causes and solutions for wear of steel plate telescopic protective cover in machining center

In the machining center industry, there is a high degree of dependence on the steel plate retractable shield, which also promotes the main reason why the steel plate telescopic shield of the machining center is so widely used. The popularity of popular products is not to be underestimated. The understanding of each of them is very different. One problem is that everyone is most concerned about how to reduce wear and extend service life.

Everyone may know that the steel plate telescopic shield of the machining center has the functions of acid and alkali resistance, corrosion resistance and rust prevention. Why is there such a large characteristic wear and tear?

1. The processing center steel plate telescopic shield can be used in an environment of 900 ° C, so the parts of the product may be damaged more or less in this high temperature environment. The solution to this situation is that the folded surface of the shield and the parts are assembled with a higher temperature resistant material to reduce wear.

2, long, in addition to high temperature work, there are lubrication. The measure taken is to apply molybdenum disulfide on the surface of the product, depending on the situation.

3. When the working time of the steel plate telescopic protective cover of the machining center reaches one month, it is necessary to clean the inside and outside, and check whether the product has serious wear and rupture. If necessary, replace it in time to avoid affecting normal operation. .