Eye drops filling machine steps

The eye drop filling machine is an automatic machine, so the size of the easy-open bottle, the bottle pad and the cap are required to be uniform. You must first use the rocker to turn the machine to see if it is abnormal, and you can actually drive it. When adjusting the machine, the tool should be used properly. It is strictly forbidden to use excessive tools or excessive force to remove the parts to avoid damage to the machine or affect the performance of the machine. Whenever the machine is adjusted, be sure to tighten the loose screws. Rotate the machine with the rocker to see if the motion meets the requirements before driving.

Eye drops filling machine operation steps:

1. Place the filled liquid bottle upside down on the work basket and check that the liquid bottle bottom is aligned.

2. Place the vacuum basket in a vacuum filling, cover the lid quickly and lock it.

3. Close the venting valve, the inlet valve, open the vacuum pump, adjust the true air conditioning valve to make the vacuum (depending on the amount of trial filling) to meet the process requirements, and step on the pedal to insert the liquid into the liquid bottle.

4. Slowly open the inlet valve. At this time, the liquid level in the filling rises and the vent valve is opened to keep the liquid level between the specified liquid level of the sight glass.

5. When the vacuum gauge pointer is in the 0 state, it is proved that the liquid filling is completed, and the foot collapsed plate is returned, and the liquid bottle which is quickly opened and the can lid is taken out and filled.

6. For the troubleshooting of vacuum mercury (see XD series but the rotary vane vacuum pump instruction manual), the vacuum pump should not be used for a long time (more than seven days). The oil used in the mercury should be drained and flushed with new oil. Moisture in the oil prevents corrosion of the pump body.