Human Angiopoietin 2 (ANG-2) ELISA Test Kit Instruction Manual

This kit can only be used for scientific research and should not be used for medical diagnosis.

Human Angiopoietin 2 (ANG-2) ELISA Test Kit Instruction Manual

Detection principle

The kit uses a double antibody one-step sandwich enzyme-linked immunosorbent assay (ELISA). To the coated microwells pre-coated with angiopoietin 2 (ANG-2) antibody, specimens, standards, and HRP-labeled detection antibodies were sequentially added, and the cells were washed and thoroughly washed. Using the substrate TMB to develop color, TMB is converted to blue under the catalysis of peroxidase and converted to the final yellow color by the action of an acid. The depth of the color is positively correlated with Angiopoietin 2 (ANG-2) in the sample. The absorbance (OD value) was measured at 450 nm using a microplate reader to calculate the sample concentration.

Sample collection, processing and storage methods

1. Serum: Use a tube containing no pyrogen and endotoxin. Avoid any cell irritation during the procedure. After collecting the blood, centrifuge and centrifuge for 10 minutes at 3000 rpm to quickly and carefully separate the serum and red blood cells.

2. Plasma: EDTA, citrate or heparin anticoagulation. The supernatant was taken by centrifugation at 3000 rpm for 30 minutes.

3. Cell supernatant: Centrifuge at 3000 rpm for 10 minutes to remove particles and polymer.

4. Tissue homogenization: The tissue is mashed by adding appropriate amount of physiological saline. The supernatant was taken by centrifugation at 3000 rpm for 10 minutes.

5. Storage: If the sample is not detected in time after collection, please dispense it once, freeze it at -20 °C, avoid repeated freezing and thawing, thaw at room temperature and ensure that the sample is fully thawed evenly.

Bring your own items

• Microplate reader (450nm)
• High-precision sampler and tip: 0.5-10uL, 2-20uL, 20-200uL, 200-1000uL
• 37 ° C incubator

Operational precautions

1. The kit was stored at 2-8 ° C and equilibrated for 20 minutes at room temperature before use. The concentrated washing liquid taken out from the refrigerator will crystallize, which is a normal phenomenon, and the water bath is heated to completely dissolve the crystals before use.
2. The slats not used in the experiment should be immediately put back into the ziplock bag and sealed (low temperature dry) for storage.
3. The S0 standard with a concentration of 0 can be regarded as a negative control or blank. The sample has been diluted 5 times according to the instructions. The final result multiplied by 5 is the actual concentration of the sample.
4. Incubation is carried out in strict accordance with the time indicated in the instructions, the amount of liquid added and the order.
5. Shake well all liquid components before use.

Kit composition

Note: The concentration of standard (S0-S5) is: 0, 1.5, 3, 6, 12, 24 ng/mL

Reagent preparation

Dilution of 20× Wash Buffer: Distilled water was diluted 1:20, ie 1 part of 20× Wash Buffer plus 19 parts of distilled water.

Washing method

1. Manually wash the plate: Drain the liquid in the hole, fill each hole with the washing liquid, let stand for 1 min, then drain the liquid in the hole, pat dry on the absorbent paper, and wash the plate 5 times.
2. Automatic washing machine: Inject 350 μL of washing solution into each well, soak for 1 min, and wash the plate 5 times.

Steps

1. The required slats were taken out from the aluminum foil pouch after equilibrating for 20 min at room temperature, and the remaining slats were sealed back to 4 ° C with a ziplock bag.
2. Set standard and sample wells, standard wells with different concentrations of standard 50μL;
3. The sample hole to be tested is first added with 10 μL of the sample, and then 40 μL of the sample diluent (ie, the sample is diluted 5 times); the blank hole is not added.
4. In addition to the blank wells, 100 μL of horseradish peroxidase (HRP)-labeled detection antibody was added to each well of the standard well and the sample well, and the reaction well was sealed with a sealing plate, and incubated at 37 ° C in a water bath or incubator for 60 min.
5. Discard the liquid, pat dry on the absorbent paper, fill each well with the washing solution, let stand for 1 min, remove the washing solution, pat dry on the absorbent paper, and repeat the washing 5 times (can also be washed with a washing machine).
6. 50 μL of each of the substrates A and B was added to each well, and incubated at 37 ° C for 15 min in the dark.
7. 50 μL of the stop solution was added to each well, and the OD value of each well was measured at a wavelength of 450 nm within 15 min.

Result judgment

Draw a standard curve: In the Excel worksheet, the standard concentration is used as the abscissa, and the OD value is plotted as the ordinate. The linear regression curve of the standard is drawn, and the concentration values ​​of each sample are calculated according to the curve equation.

Kit performance

• Accuracy: The linear regression coefficient of the standard and the expected concentration correlation coefficient R value, greater than or equal to 0.9900.
• Sensitivity: The minimum detection concentration is less than 0.1 ng/mL.
• Specificity: Does not cross-react with other soluble structural analogs.
• Repeatability: The coefficient of variation between the plates and the plates is less than 15%.
• Storage: 2-8 ° C, protected from light and moisture.
• Validity: 6 months

Disclaimer

• The kit is for research use only and should not be used for clinical trials or human experiments. Otherwise, the consequences will be borne by the experimenter and the company will not be responsible.
• In strict accordance with the instructions, the experimenter violates the instructions, and the consequences are borne by the experimenter.

Shanghai Yuduo Biotechnology Co., Ltd. produces and sells elisa kit, animal serum, plasma, whole blood, antigen and antibody, gold standard kit test card, antiserum, biological reagents, culture medium, laboratory equipment consumables, chemical reagents, biological products. , standard products, reference products, biochemical immunological products, immunoaffinity columns, strains, plasmids, indoor quality control products, cells, ice packs, agent imported products, etc.

Large favorably! Welcome dealers to discuss cooperation matters!

Contact Phone Contact QQ

Wrist Blood Pressure Machine

Electronic smart digital Upper arm and Wrist Blood Pressure Monitor automatic.

we are manufacturer of Blood pressure monitor for more than 12 years, we can accept OEM/ODM as for your requirements.

More closer to our peoples' heart, so the result of measurement will be more accurate.

Main Feautures For Electronic Sphygmomanometer Automatic BP Machine Digital Upper Arm Blood Pressure Monitor:

· Measurement method: oscillometric method

· Display screen: LCE big digital display shows high pressure / low pressure / pulse

· Blood pressure classification: WHO sphygmomanometer classification indicates blood pressure health

· Intelligent pressurization: automatic pressurization and decompression, IHB heart rate detection

· Year/month/day time display

· 2*90sets of measurement results memory for two people; the average reading of the last 3 measurements for data comparison

· One button measuremment,automatic turn on-off for convenient operation

· Blood pressure value unit Kpa and mmHg for conversion (boot default unit is mmHg)
Comfortable cuff included

· voice broadcast function is optional,any OEM demand available

Wrist Blood Pressure Machine:Digtal Blood Pressure Machine:Electric Blood Pressure Machine:

Shenzhen Urion Technology Co., Ltd. , https://www.urionhealth.com