During the operation of the domestic large-scale pipeline centrifugal pump , the vibration is large, the upper and lower bearings are often heated, damaged, and even the connection between the pump shaft and the bearing is worn. The pump is unstable and affects the normal water supply. It needs to be damped.
First, the pump vibration causes analysis 1, the domestic vertical water pump 28SLA-10 is directly transformed from the horizontal pump. The vertical height between the motor base and the pump base is 4.3m, and the drive shaft weighs 3t. Compared to the horizontal pump, it adds an intermediate drive shaft with a length of 3752 mm and a diameter of 140 mm. Structurally, no modifications were made except for the addition of a bearing to the intermediate drive shaft (as shown in Figure 1). The operating pressure of the four pumps is 0.7 to 0.85 MPa for a long time. Under the conditions of high lift and large flow, such a system with high center of gravity and high mass rotates at high speed, and the centrifugal force generated is very large, which will cause large vibration of the unit. In addition, the joint rigidity of the bracket and the water pump in the direction of water inlet and outlet is insufficient, resulting in a large displacement of the water pump and each connecting piece. The displacement of the water pump during operation causes the upper bearing to change its force condition, and the vibration is increased, so it is easy to generate heat. If the displacement of the pump is corrected and the bearing stress condition is improved, the vibration intensity of the system can be reduced.
2. There is a rigid connection between the pump and the drive shaft. Due to manufacturing and installation reasons, the pump shaft is concentric with the drive shaft during operation, causing the pump to vibrate; the vibration generated by other sources such as the motor and the drive shaft is also directly transmitted to the water pump to form a superposition of vibrations, further increasing the vibration of the pump . In addition, this rigid connection increases the external force on the bearing on the water pump, causing the bearing to be prone to heat and affecting the pump shaft.
Second, the transformation situation For the above reasons, we have taken the following two steps to transform.
1. Strengthen the rigidity of the pipeline. Taking into account the pump reinforcement is difficult to take measures in the pump outlet pipe welding "stiffener" of. In the direction of the inlet and outlet, the flanges at both ends of the connecting steel pipe between the pump outlet and the outlet valve are welded by 8 steel plates with a thickness of 32 mm and a width of 100 mm. Increase the rigidity of the steel pipe, reduce the amount of deformation, and resist the displacement of the pump . After measurement, after the reinforcement, the displacement of the pump A point is reduced to 0.35mm.
2. Transform the transmission system. In order to reduce the vibration of the motor and the drive shaft to the water pump, the rigid connection between the water pump and the drive shaft is changed to an elastic connection. Using GB4323-84 elastic sleeve pin coupling, Zui large compensation displacement is 0.6mm, and the compensation angle is 1°30′. In this way, the vibration of the motor and the drive shaft can be compensated by the elastic coupling and will not be directly transmitted to the water pump .
3. After the transformation results were reconstructed, the vibration of the pump was reduced from the vibration speed of 4.3cm/s before the transformation to 1.48cm/s. According to the vibration intensity standard ISO2372-1974, the pump operation is in an excellent area. At the same time, the pump runs smoothly, the upper bearing only needs normal maintenance, and the pump shaft is worn out, indicating that the transformation is successful.
Soft Pvc Anesthesia Mask,Anesthesia Oxygen Mask,Soft Anesthesia Mask,Pvc Anesthesia Mask
K-MED Co., Ltd. , https://www.kmedasia.com