At present, the agricultural production in the spring has been fully rolled out, and the string of agricultural production safety must be tight. While strengthening the supervision of agricultural machinery production safety, the agricultural machinery department must also constantly warn farmers of 10 common misuses that farmers must avoid in the use of agricultural machinery in agricultural production.
The wrong way to support the vehicle
When tyres are damaged or replaced, it is not safe to use bricks, stones, wooden blocks or a single jack to support them. The correct approach should be to use a jack and a solid wooden pier to lift the frame at the same time. In addition, the front and rear wheels are locked with triangular wood or larger stones to prevent the vehicle from moving back and forth, supporting the collapse and injury. This kind of maintenance is best done on a solid ground to prevent tipping and hurting people.
Tire inflation is not safe operation
After the tires are unloaded, they are re-inflated and no protection is provided. The correct method is to lock the tire, the lock ring, the collar, and the rim together with a chain before inflating; and to inflate the side of the collar toward the ground or the wall to prevent the rim from being wounded.
Debug the wrong operation of the engine
When commissioning the machine, personnel approached dangerous parts such as fans, transmission belts or exhaust pipes, or placed tools and parts on the machine to cause injuries or damage. Debugging personnel should wear neat clothes, ladies should set their hair up, non-debugging personnel should stay away from the machine, try to stop when debugging, must be turned off when debugging in the lower part of the machine, must dispatch personnel to guard and control the mechanism to prevent outsiders from moving; start after debugging Before you check the tools and parts, send a signal.
Maintaining the wrong operation of the conveyor
Move the hand or other object to the transmission part; the belt joint is not firmly installed; the belt is belted during the operation of the machine; the belt is pulled by hand; the machine does not turn off when the belt tightness is adjusted; and it crosses over the belt.
The wrong way to start with start rope
When starting with the starter rope, start the rope around the hand to pull the rope, or start the rope around the flywheel for more than 1.5 turns; when the hand rotates the flywheel, it will continue to oil, power off, and turn too fast, resulting in sudden burst, rebound and injury finger.
Hand-cranked start wrong operation
When the serviceman cranks the engine by hand, separate the grip from the other four fingers with his thumb instead of holding the handle with his fingers together; lower the handle instead of lifting the handle; hold the handle and shake it with both hands. Any such operation is improper and it is easy to damage the arm or fingers. In particular, it is more prone to strike back if the ignition advances too much or the overheating starts.
Incorrect operation when refueling
Smoking or ignition when filling fuel tanks or checking oil levels; lighting with open flames during refueling at night; such as portable lights, candles, lighters, torches, etc., instead of safety lights, battery lights, or lighting; refueling on exhaust pipes On one side, the oil droplets are not wiped clean outside the box and they drip on the clothes. When they are not dry, they are close to an open flame or smoke. After the fire is over, the fuel is poured instead of covered with sand, dry soil, canvas, sacks, etc.; Gasoline mouth suction pipe, or mouth contact with oiled parts, causing poisoning.
The wrong practice of adding water
Open the tank lid immediately when the engine is hot, especially in the open condition. Instead of turning on the water switch first, after the water pressure is lowered, wrap the water tank cover with a towel, etc., and tilt the head slowly to the side after the body's face.
Eliminate wrong practice when driving
After a locomotive or rice transplanter emerges, people stop or work in front of the car. Once the locomotive or transplanter comes into contact with the car, it will suddenly cause injury and cause an accident.
Improper operation when disassembling the spring
Disassembly and assembly of clutch springs, valve lock clips, etc., without special tools, and picking up with a screwdriver, etc., will cause springs to pop and hurt people.
Zhejiang Industrial Group Co., Ltd. , https://www.xingyeseafood.com