How much is a ton of thin steel structure fireproof coating in Weinan

Haonan's good thin steel structure fireproof coating. One ton of thin steel fireproof coating is a high-quality and high-efficiency thermal insulation material that integrates closed microporous structure and mesh fiber. In the temperature range of use, it can be used for a long time, it is not easy to aging, it is not degraded, it is odorless, and the heat preservation performance is not reduced for a long time.

The thin steel structure fireproof coating is suitable for fire protection of various steel structure engineering load-bearing members with fire resistance requirements greater than 2h. Such as aerospace, petroleum, chemical, electric power, metallurgy, national defense, textile industry and other outdoor buildings, special fire-resistant steel structural parts, fire protection, especially suitable for manufacturers of thin steel fire-retardant coatings, some of them have hydrocarbon chemicals (such as oil, solvent, etc.) fire hazard steel structure engineering, such as petrochemical engineering, automobile warehouse, oil drilling platform, fire protection of oil storage support frame.

Strong adhesion: strong adhesion to epoxy, alkyd and phenolic anti-rust primers, strong durability, wide application, high quality and low price

What are the performance characteristics of thin steel fireproof coatings:

State in the container

Drying time (dry)

Initial dry crack resistance

What are the bond strengths of thin steel fireproof coatings?

Compressive strength MPa

Resistance to freezing and thawing cycles, times

Fire resistance

After stirring, it is in a uniform thick fluid state without agglomeration.

≤3h

1-3 cracks are allowed, and the width should be no more than 0.5 mm

≥0.15

≥0.05

≥15 coating should be free of cracking, shedding and blistering

Coating thickness ≤ 3.7mm

Fire resistance limit ≥ 2h

Convenient construction: spraying, roller coating, brushing can be.

) construction method:

1. Before use, the surface of the object to be coated should be cleaned of oily dirt and the like.

2. The solid content of the paint is high, and the paint must be stirred before use.

3. Brush, roll, spray, you can brush the second road every six hours.

4. The thickness of the coating can be determined according to the requirements of the fire code, usually 2-6 channels.

WB-CDGC-A5. Unfinished paint, to be re-sealed.

Packaging and transportation:

1. WB (CDGC-A) type plastic drum packaging.

2. Storage and transportation temperature should be 3-40 ° C, not stored outdoors and exposed to the sun.