Weighbridge - how to do partial load

Explosion-proof electronic platform scale, explosion-proof electronic scale, explosion-proof floor scale - how to do partial load

1. We should carefully check the explosion-proof electronic weighbridge limiter device. If we find that the electronic weighbridge gap is too small, we have to adjust it. Generally, it is better to adjust it between three millimeters and five millimeters.

2. We must carefully check whether the load cell has fallen vertically. If there is any problem, we need to adjust the eccentric load to the proper position.

3. Check whether the electronic components of the electronic platform are disconnected or loose. If any problem is found, we need to tighten the spring pad, but be careful not to use too much force.

After the explosion-proof electronic platform is ready for the above-mentioned debugging, we will test it next.

1. We first remove the goods on the electronic platform scale, and then clear it to see if it meets the requirements of the regulations. If there is any deviation, we will do the next inspection.

2. Select the potentiometer to be debugged by the explosion-proof electronic platform, then adjust and observe the change of the potentiometer, and note the number of adjustment coils, direction, etc. When it is found that there is a change, we will adjust the potentiometer repeatedly, and then we can The problem of electronic platform eccentricity is solved.